Skip to content

Free in-home estimate, drop cloths down first

(562) 554-5955
(562) 554-5955

ServicesCustom Glass Railings

Custom Glass Railings in Whittier

We design and install glass railings for decks, balconies, patios and stairs. You keep the view, meet guard height and opening rules, and get hardware anchored into solid structure. We protect your home while we work and leave the area swept and the glass wiped down.

Over-the-shoulder view of an installer in gloves setting a clear glass railing panel into a metal base shoe on a backyard deck beside a stucco house

A Guard You Can See Through

A glass railing is a guard first and a view second. Each panel has to hold back a person leaning on it, so the glass, the clamps and what they bolt into all matter. We use safety glazing rated for guard use. For certain systems that means laminated tempered glass, which stays in place as one sheet if it ever breaks.

Glass is the right call when an old wood or wrought iron railing blocks the yard or hills, has rusted at the posts, or has gone loose at the base. It also makes sense on a new deck or balcony where you want clean lines with less upkeep than painted pickets.

Railings attach to the outside of your home, often through stucco or deck boards. We treat those spots carefully so water does not get in behind the work.

What the Work Includes

Measuring and layout

We measure every run, corner and stair angle, and check how far the walking surface sits above grade. Guards are required once a surface is more than 30 inches up, and openings must stop a 4-inch sphere from passing through.

Choosing the mounting system

Options include a continuous aluminum base shoe, stainless or aluminum posts with glass clamps, and standoff pins on the fascia. We explain how each one loads the structure and which fits your deck or slab.

Glass selection

Clear, low-iron or frosted panels, sized to your layout. Thickness depends on panel width and the mounting method, so we specify it to suit the load rather than picking a stock size.

Top rail and handrail

Many systems use a cap rail that ties the panels together. On stairs we add a graspable handrail where code calls for one.

Removal of the old railing

We cut out the existing railing, pull the fasteners, and haul the metal and wood away so nothing is left stacked against the house.

Sealing and cleanup

Every penetration through stucco, membrane or decking gets sealed. At the end of each day we sweep up drill dust and metal shavings and wipe smudges off the new glass.

Signs It Is Time for a New Railing

  • Posts that move

    If a post wobbles when you push it, the fasteners or the framing below have likely loosened or rotted. That is a safety problem, not just a looks problem.

  • Rust at the base

    Wrought iron rusts first where it meets concrete or a deck surface, because water sits there. Once the metal swells it can crack the concrete around it.

  • Gaps that are too wide

    Older railings often have spacing that a small child could slip through. Glass panels close those gaps with a solid infill.

  • A blocked view

    Pickets and lattice cut the view from your deck into strips. Glass lets you see the yard or the hills from a seated chair.

  • Constant repainting

    Wood railings need sanding and paint every few years in Southern California sun. Glass and powder-coated aluminum mostly need a rinse.

How the Job Runs

  1. 1

    Free in-home estimate

    We visit, measure, look at the framing or slab the railing will attach to, and talk through mounting and glass options. There is no sales pressure or obligation.

  2. 2

    Permit and ordering

    If your project needs a permit, we tell you before work starts and handle the paperwork. Glass is tempered to exact size, so we order it after final measurements are confirmed.

  3. 3

    Protecting the area

    On install day we lay drop cloths over the deck and nearby plants, and cover any windows or doors close to the cutting and drilling.

  4. 4

    Installation

    We remove the old railing, set the base shoe or posts into solid structure, then set and level each panel and tighten the clamps or gaskets.

  5. 5

    Final check and cleanup

    We load-test each section by hand, check heights and gaps, seal the penetrations, and clean the glass. Debris leaves with us.

What Affects the Cost

Glass railings are priced by the run, but the details underneath move the number more than people expect. We give you a written estimate that shows what each part of the job covers.

Length and layout
Total linear footage sets the base. Corners, curves and stair runs need angled panels and more hardware than one straight run.
Mounting method
A full base shoe uses more aluminum but gives a clean frameless look. Post systems use less metal along the floor but more fittings.
What it attaches to
Concrete, wood framing and a stucco-wrapped balcony each need different anchors. Rotted joists or a damaged membrane must be fixed before the railing goes on.
Glass type and finish
Laminated glass costs more than single tempered panels. Low-iron, frosted or tinted glass and specialty hardware finishes also add to the price.
Permits and access
A required permit adds fees and inspection time. Second-story balconies with tight access take longer to stage safely.

Glass Railing Questions

Something not covered here? (562) 554-5955

Is glass strong enough for a railing?

Yes, when it is the right glass in the right system. We use safety glazing sized for guard loads, and laminated tempered glass where the system calls for it. The hardware and anchors are just as important, which is why we check the structure first.

How hard are glass railings to keep clean?

Easier than most people think. Rinsing with a hose and wiping with a squeegee handles dust and water spots. Low-iron glass shows less of a green tint, and frosted glass hides spots better than clear.

Can you put glass railings on my existing deck?

Often, yes. We look at the joists, rim board or slab during the estimate. If the framing is sound, we anchor into it. If it is soft or undersized, we tell you before quoting the railing.

Will drilling into stucco cause leaks?

Not if the holes are sealed correctly. We seal every fastener that goes through stucco or a deck membrane, so water has no path into the wall or the framing below.

How long does installation take?

Most residential railings go in over one to a few days, depending on length and stairs. The longer wait is the glass itself, since each panel is tempered to size after we confirm measurements.

Single-story stucco house with new white-framed windows on each side of a black entry door with glass sidelites, shrubs, lawn, walkway, and a tool bin and bucket

See Your Deck Without the Pickets

We will measure your deck, balcony or stairs, check what the railing will anchor into, and walk you through glass and mounting options. We serve Whittier and nearby towns such as La Habra and Hacienda Heights.